Common problems of rubber tyre shredder

Rubber tyre shredder equipment failure requires your timely attention, if found that the output of shredder decreased, while the raw materials remain unchanged, it is necessary to check whether the air supply valve is in place, whether there is air leakage in the pipeline, etc., shredder blockage is also a common failure. When encountering relevant faults, don't panic. First check the faults, then do the corresponding countermeasures. Next, we briefly introduce the causes and solutions of the blockage of the inlet and outlet. There are four reasons for the blockage of the inlet and outlet: first, it may be the design problem of the body; second, the material is put in too fast; third, the pipeline is not smooth; fourth, it may be that the water content of the raw material is too high, bearing should be paid special attention to when working. When the temperature is too high or there is noise, it is usually the lubricant or the bearing cover and shaft are too tight to match, this situation will occur. Solutions: 1. Reasonable control of feeding volume, prohibit large bundles of materials directly into the machine; 2. Ensure that materials are fed along the length direction to avoid transverse feeding; 3. Material is stuck between the upper drum of the second pair of drums arranged by the rubber shredder feeding arrangement and can only be poked down with wooden sticks; 4. Avoid using iron to poke, so as to avoid serious accidents falling into the machine.